Exegin Technologies Limited 58Q3 Manuel D’Utilisation
11
Q58 OEM Manual
© 2014 Exegin Technologies Limited
3. Q58 Regulatory information
Radio Frequency Notifications
Radio Frequency Notifications
3
Q58 R
EGULATORY
INFORMATION
Introduction
RF modules like the Q58 are intended for original equipment manufacturers who wish
to add a wireless interface to their products without incurring the cost of regulatory
testing as an intentional radiator. To market products in different parts of the world,
OEMs must comply with rules established by different regulatory agencies as follows.
to add a wireless interface to their products without incurring the cost of regulatory
testing as an intentional radiator. To market products in different parts of the world,
OEMs must comply with rules established by different regulatory agencies as follows.
Radio Frequency Notifications
FCC
Notifications
Q58 802.15.4 SPI Modules comply with Part 15 of the FCC rules and regulations. To
fulfill FCC Certification requirements, the OEM must comply with the following
regulations:
fulfill FCC Certification requirements, the OEM must comply with the following
regulations:
1. The Q58 must be labelled with its own FCC ID number and, if the FCC ID is not
visible when the module is installed inside another device, then the outside of the
device into which the module is installed must also display a label referring to the
enclosed module.
device into which the module is installed must also display a label referring to the
enclosed module.
2. Only the tested and approved antennas listed in Table ?? may be used with the
module.
OEM Labeling
Requirements
Requirements
WARNING: The OEM must ensure that FCC labeling requirements are met. This
includes a clearly visible label on the outside of the final product enclosure that displays
the contents shown in
includes a clearly visible label on the outside of the final product enclosure that displays
the contents shown in
Figure 1— FCC Labeling Requirement
Notices
IMPORTANT: The Q58 is limited to OEM installation ONLY. The OEM integrator is
responsible for ensuring that the end-user has no manual instructions to remove or install
the Q58.
responsible for ensuring that the end-user has no manual instructions to remove or install
the Q58.
Contains FCC ID: VQ458Q3
Contains IC ID: 7162A-58Q3
Contains IC ID: 7162A-58Q3
The enclosed device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (i) this device may not cause
harmful interference and (ii) this device must accept any interference
received, including interference that may cause undesired operation.
subject to the following two conditions: (i) this device may not cause
harmful interference and (ii) this device must accept any interference
received, including interference that may cause undesired operation.