Exegin Technologies Limited Q53 Manuel D’Utilisation
31
Q53 Installation and Configuration Guide © Exegin Technologies Limited, 2009
vi. Q53 Zigbee PAN and Bridge Configuration
Required Zigbee Settings
Required Zigbee Settings
vi
Q53 Z
IGBEE
PAN
AND
B
RIDGE
C
ONFIGURATION
This chapter describes how to configure the required and optional Zigbee Personal Area
Network (PAN) and bridge settings for the Q53. The following steps are covered:
Network (PAN) and bridge settings for the Q53. The following steps are covered:
•
•
•
•
•
•
•
•
•
•
•
•
Required Zigbee Settings
Selecting the RF Channels
As shipped from the factory the Q53 is configured to operate on channel 11 for the 2.4
GHz radio.
GHz radio.
The Q53 must be configured to use the same radio channel(s) as the other nodes in the
local Zigbee PAN. This configuration may be performed using HTML forms.
local Zigbee PAN. This configuration may be performed using HTML forms.
Using HTML
forms
forms
1. Load the Q53 HTML forms as described in
on page 18, then select
"Zigbee" from the Main Menu.
Or, go directly to the Zigbee Configuration form by typing the following into your
browser:
browser:
http://Q53IPaddress/zigbeeConf.html
The Zigbee Settings configuration form is displayed (
).