Exegin Technologies Limited Q53 Manuel D’Utilisation
47
Q53 Installation and Configuration Guide © Exegin Technologies Limited, 2009
vii. Using HTML Pages to Configure the Q53
TCP/IP Forms
TCP/IP Forms
TCP/IP Forms
TCP/IP Settings Form
The TCP/IP Settings form appears as is shown in
Figure 18—TCP/IP Settings Form
Static vs
Dynamic
Addressing
Dynamic
Addressing
The Q53 may be set up to automatically request its TCP/IP parameters over the network
from a DHCP (Dynamic Host Configuration Protocol) server. To enable this feature,
click on the radio button labelled ’Obtain an IP address automatically’. When this feature
is enabled, the DHCP server will provide all TCP/IP configuration data; in this case,
none of the other fields on the TCP/IP Settings form need to be filled in.
from a DHCP (Dynamic Host Configuration Protocol) server. To enable this feature,
click on the radio button labelled ’Obtain an IP address automatically’. When this feature
is enabled, the DHCP server will provide all TCP/IP configuration data; in this case,
none of the other fields on the TCP/IP Settings form need to be filled in.
If static addressing is desired, then click on the radio button labelled ’Use the following
IP address’. For static addressing, the IP address and Subnet mask are required to be
entered. All other parameters are optional, depending upon your installation
requirements.
IP address’. For static addressing, the IP address and Subnet mask are required to be
entered. All other parameters are optional, depending upon your installation
requirements.
Default: Unconfigured (blank) IP address and subnet mask; dynamic addressing
enabled.
enabled.