Hansong Technology Ltd. HSMLV2E Manuel D’Utilisation

Page de 5
© audio pro aB sverige
audio pro
®
 , audio pro logotypen, ‘a’ symbolen, och ace-bass®  är registrerade varumärken av audio pro aB, sverige. 
alla rättigheter reserverade. audio pro följer en policy om ständig produktutveckling. specifikationer kan ändras utan 
föregående meddelande. 
© audio pro aB sweden
audio pro
®
, the audio pro logotype, the ‘a’ symbol, and ace-bass® are all registered trademarks of audio pro aB, sweden.  
all rights reserved. audio pro follows a policy of continuous advancement in development. specifications may be changed 
without notice. 
www.audiopro.com
www.audiopro.se
this equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 
part 15 of the FCC rules. these limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. this equipment generates uses and can radiate radio frequency energy 
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio 
communications. however, there is no guarantee that interference will not occur in a particular installation.  
if this equipment does cause harmful interference to radio or television reception, which can be determined 
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more 
of the following measures:
– reorient or relocate the receiving antenna.
– increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/tv technician for help.
 
to satisfy FCC rF exposure requirements, a separation distance of 20 cm or more should be maintained 
between this device and persons during device operation. to ensure compliance, operations at closer than 
this distance is not recommended. the antenna used for this transmitter must not be co-located in conjunction 
with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject  to the following two conditions:  
(1) this device may not cause harmful  interference, and (2) this device must accept any interference received,  
including interference that may cause undesired operation.
Pour satisfaire aux exigences de la FCC d’exposition aux radiofréquences, une distance de séparation de  
20 cm ou plus doit être maintenue entre cet appareil et des personnes lors de fonctionnement du dispositif.  
Pour assurer la conformité des opérations au plus près que cette distance n’est pas recommandée. L’antenne 
utilisée pour ce transmetteur ne doit pas être co-localisés en conjonction avec toute autre antenne ou transmetteur.
Cet appareil est conforme à la Partie 15 des règlements de la FCC. L’opération est soumise aux deux condi-
tions suivantes: (1) cet appareil ne peut causer d’interférences nuisibles, et (2) cet appareil doit accepter toute 
interférence reçue, y compris les interférences qui peuvent provoquer un fonctionnement indésirable.
Wireless loudspeaker lv2 e 
FCC id: XCO-hsmlv2e
FCC iC: 7756a-hsmlv2e
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and 
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio inter-
ference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically 
radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Conformément à la réglementation d’Industrie Canada, le présent émetteur radio peut
fonctionner avec une antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur par 
Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l’intention des autres 
utilisateurs, il faut choisir le type d’antenne et son gain de sorte que la puissance isotrope rayonnée équiva-
lente (p.i.r.e.) ne dépasse pas l’intensité nécessaire à l’établissement d’une communication satisfaisante.