Bently Nevada Inc. 18531001 Manuel D’Utilisation
Essential Insight.mesh
TM
Installation and Maintenance Manual
36
of attaching wSIMs or Repeaters to ferrous metal
surfaces. The mounting surface should be flat and
larger in diameter than the magnet mount assembly.
surfaces. The mounting surface should be flat and
larger in diameter than the magnet mount assembly.
Caution
Pinch hazard – wSIM and Repeater
magnet mounts have pull strength of
up to 200 lbs.
5.3.3 Mount a node to a Hex Mounting Base
A wSIM or Repeater is installed and secured to the
Hex mounting base as shown below:
Hex mounting base as shown below:
Follow the steps given below to install a wSIM or a
Repeater on the mounting base:
Repeater on the mounting base:
1. Slide the base of the battery power module
so that the two slots
on the battery module
line up with the locking
pins on the hex
mounting base.
on the battery module
line up with the locking
pins on the hex
mounting base.
2. Twist the battery module
clockwise until the locking
pin slides to the end of the
slot on the battery module
and the corners of the hexagon surfaces are
aligned.
pin slides to the end of the
slot on the battery module
and the corners of the hexagon surfaces are
aligned.