Shenzhen AEE Technology CO. LTD. AEEAP100001 Manuel D’Utilisation

Aerial Photography Equipment

 Professional·Advanced

 

 

- 13 - 

 

Turn the left joystick to the upper left corner                        Turn the right joystick to the upper right corner 

 

3.  Calibration of compass: Place the aerial photography equipment on a horizontal plane; at this moment, the rear 

lights (red) turn constantly on. Turn the joysticks to an upper toe-in shape (as shown in the figure) until the front 

lights (green) begin to flash, and then loosen the joysticks; the aerial photography equipment begins compass 

calibration.  

 

Turn the left joystick to the upper right corner                        Turn the right joystick to the upper left corner 

 

As shown in the figure below, first hold the aerial photography equipment to make it slowly rotate by 360° along the 

horizontal plane; then inversely rotate the aerial photography equipment by 360° along the vertical plane of the 

equipment; rotate several circles when the green lights are flashing to obtain adequate compass data until the front 

lights (green) turn off. Place the aerial photography equipment on a horizontal ground; when the front lights (green) of 

the aerial photography equipment turn on, the calibration is finished. During calibration, do not shake or move the 

aerial photography equipment.   

 

 

Fly control modes 

The aerial photography equipment has two fly control modes: manual fly control mode (“MC”) and GPS fly control 

mode (“AC”).   

1.  S4 on the remote control is the mode control switch which can realize the switch between “MC” (manual fly 

control mode) and “AC” (GPS fly control mode). 

2.  It is suggested that S4 should be turned to “MC” position before each flight so that the equipment will take off at