Technology Solutions Ltd 1153 Manuel D’Utilisation
1153 UHF Reader User Guide V1.23
© Technology Solutions (UK) Ltd 2014
24
REGULATORY INFORMATION
RF EXPOSURE GUIDELINES
Safety information – To reduce RF exposure only use the device in accordance with the instructions supplied.
To comply with FCC RF exposure compliance requirements this unit must be operated in the hand with a minimum
separation of 20cm from the body and other persons. Other operating configurations should be avoided. This
unit must not be co-located or operated in conjunction with any other transmitter / antenna except those already
approved in this filing.
separation of 20cm from the body and other persons. Other operating configurations should be avoided. This
unit must not be co-located or operated in conjunction with any other transmitter / antenna except those already
approved in this filing.
LASER WARNING
A warning label is also shown on the side of the reader when a barcode
reader is fitted.
reader is fitted.
The barcode reader module complies with 21 CFR 1040.10 and 1040.11
except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007,
EN60825-1:2007 and IEC60825-1:2001 (Ed.1.2)
except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007,
EN60825-1:2007 and IEC60825-1:2001 (Ed.1.2)
Avoid unnecessary exposure to the laser light.
Caution:
Use of controls, adjustments or performance of procedures other
than those specified herein may result
in hazardous laser light exposure.
in hazardous laser light exposure.
Caution:
Viewing the illumination from the barcode reader with optical
instruments may result in increased hazard.
WARNING
LASER LIGHT.
DO NOT STARE INTO BEAM.
CLASS 2 LASER
PRODUCT.
LASERSTRAHLUNG
NICHT IN DEN STRAHL BLICKEN.
LASER KLASSE 2.
LUMIÈRE
LASER NE PAS REGARDER
DANS LE FAISCEAU. APPAREIL
À LASER DE CLASSE 2.
630-670nm 1mW
INFORMATION TO THE USER – FCC
FCC warning statement:
This device complies with Part 15 of the FCC Rules.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
authority to operate the equipment.
www.tsl.uk.com