Sena Technologies Inc. PARANISD1100 Manuel D’Utilisation
11
2.2. LED Indicators
RS422/485-Tx and RS422/485-Rx LED will flash accordingly when data is transmitted. For small data
transmissions, it may be hard to recognize the quick flashing action of the LED. Charge Led and Low
battery LED will be off, if you don’t use battery pack.
Table 2-2 The Parani-SD1100 LED Indicators
Indicator
Power LED
Standby LED
Connect LED
Indicator
Mode0
Green ┏━━━━━
Red
┏━━━━━
┏━━━━━
Mode0
Mode1
Green ┏━━━━━
Green (every 1
sec) ┏┓
sec) ┏┓
Mode1
Mode2
Green ┏━━━━━
Green (every 3
sec) ┏┰┓
sec) ┏┰┓
Mode2
Mode3
Green ┏━━━━━
Green (every 3
sec) ┏┰┓
sec) ┏┰┓
Mode3
Connected
Green ┏━━━━━
Green
┏━━━━━━━
┏━━━━━━━
Connected
Indicator Power
LED
Standby LED
Connect LED
Indicator
Mode0
Green ┏━━━━━
Red
┏━━━━━
┏━━━━━
Mode0
Mode1
Green ┏━━━━━
Green (every 1
sec) ┏┓
sec) ┏┓
Mode1
2.3. Serial Ports
The applicable settings for serial ports are as follows.
Table 2-3 The Parani-SD1100 Serial Port Settings
Serial Port Settings
Values
Baud rate
1200, 2400, 4800, 9600, 14400, 19200, 38400, 57600, 115200, 230400, 460800,
921600
921600
Data bite
8
Parity
No parity, Even parity, Odd parity
Stop bit
1, 2
Hardware Flow Control
No Use
The values in box are the factory defaults.
2.4. Data Bit
Parani-SD1100 supports only 8 data bit. In the case of 7 data bit and even/odd parity, use 8 data bit
and none parity. At this time, master and slave are Parani-SD, Parani-ESD or Parani-MSP series. But
7 data bit and none parity is not support.