Sena Technologies Inc. PARANISD1100 Manuel D’Utilisation

 31

 
 

 

 

OK 

Software Reset 

This has the same effects as Powercycling the unit. 
This command disconnects any connected Bluetooth device, and stops ongoing tasks. 
After rebooting, the status will be decided by the preset operation mode. 
Some AT commands require the ATZ command be run so that the commands can take 
effect. 

 

 

 

OK 

Hardware reset 

This has the same effect as initialization by pressing the factory reset button. 
All parameters are initialized to factory defaults.   

 

 

 

OK 

Check the connection status with host equipment 

Check if the connection to host equipment is operating normally. The serial parameters of 
Parani-SD must be same as those of host equipment. If not, the Parani-SD will not respond 
or ‘ERROR’ message will appear or an abnormal sequence of strings will appear. 

 

 

 

OK 

Set Serial parameters 

Baudrate = 1200/2400/9600/14400/19200/38400/57600/115200/230400/460800/ 921600 
(Default=9600) 
Parity=N/E/O (Default=N) 
Stopbit=1/2 (Default=1) 

The Serial parameters can be set or changed only if SW config mode is selected in dip 
switch. The factory default is 9600, N, 1. 
To take effect the ATZ command must be used or Powercycle the unit. 

AT+UARTCONFIG,115200,N,1 

 

   

 

m 

Check the Baud rate set by the dip switch 

m=0: Dip switches are set to ‘S/W Config’ 
m=1: Please view the dipswitches to view your baud rate.