Sena Technologies Inc. PARANISD1100 Manuel D’Utilisation

 33

CURRENT MODE: MULTI-DROP MODE 
TASK1 – 000195000001 
TASK2 – DISCONNECT 
TASK3 – DISCONNECT 
TASK4 – 000195000004 

 

 

 

OK 

Set operation mode 

n=0: MODE0 (Default) 
n=1: MODE1 
n=2: MODE2 
n=3: MODE3 

When the operation status is ‘Pending’ currently, change the status to ‘Standby’ with 
AT+BTCANCEL prior to this command. 
To take effect the ATZ must be executed or Powercycle the unit 

AT+BTMODE,2 
OK 
ATZ 

 

 

 

OK 

Set multiple connection mode 

n=0: Single Connection Mode (Default) 
n=1: Multi-Drop Mode 
n=2: Node Switching Mode 

Set single connection mode, multi-drop mode or node switching mode. 

 

 

 

OK 

Convert the operation status of ‘Connect’ to ‘Standby’ 

In ‘Connect’ status, data from host is transmitted to the other side Bluetooth device, and 
any AT command is not accepted but this command, which is not echoed on the screen. 
When Parani-SD encounters a character ‘+’ from host, it stops the data transmission and 
waits for next 2 characters. If the next 2 characters aren’t both ‘+’, it restart to transmit data 
including the first ‘+’ as well. If not, it converts the operation status to ‘Standby’. 
If the data from host includes ‘+++’, it will convert the operation status to ‘Standby’. Notice 
that Parani-SD holds data transmission when it encounters ‘+’, until receiving next 
character. 
‘+’ is an escape sequence character by default, which is changeable by AT+SETESC. 

 

 

 

OK 

Change the escape sequence character 

Escape sequence character set to ‘+’ by default is changeable.   
The parameter nn must be a printable character.