Wistron Corporation 2008MMAPER6 Manuel D’Utilisation

• Turn the finger screw anticlockwise by a quarter turn and 

pull the battery door open. The battery door stays attached 
to the receiver via a short black strap.

• Insert the two AA batteries head-to-tail. Observe the 

polarity for each battery by reading the “+” and “-” signs 
carved onto the bottom of the battery compartment.

• Put the battery door back into place by first inserting the 

two lugs, located on either side of the strap, into the 
receiver case. Then push the door against the case and 
rotate the finger screw clockwise by one-quarter turn to 
secure the door. 

• Press the Power button briefly. (This button is located at 

the top and on the right side of the receiver).

After a few seconds, the Magellan Professional logo will 
appear on the screen, followed by the Windows Mobile 
splash screen. Then MobileMapper 6 will emit a beep 
suggesting that you tap anywhere on the screen (

screen to set up your Windows Mobile-based device) to initiate 
the setup sequence described below:

1. Screen alignment: Tap the target firmly and accurately 

at each location on the screen. The target will continue 
to move until the screen is aligned.

2. Stylus: Run this step to learn how to perform single-tap 

and tap-and-hold actions with the stylus.

3. Date & Time: Choose your time zone and enter your 

local date and time parameters.

4. Password: You can protect your data by requiring a 

password when the device is turned on. A password 
also helps to protect networks that you access. Tap 

Next 

to set up a password.