CipherLab Co. Ltd. 1664 Manuel D’Utilisation
3
Update
錯誤
! 使用 [常用] 索引標籤將 Heading 1 套用到您想要在此處顯示的文字。
Note: (1) To turn off the scanner, press the [Power/Delete] key for 2 seconds. The
scanner will respond with two short beeps (high tone) and the LED will finally
become solid red. Release the key then. Otherwise, let the scanner turn off
become solid red. Release the key then. Otherwise, let the scanner turn off
automatically in specific circumstances. Refer to settings of “
Auto Power Off
”.
(2) For shipping and storage purposes, save the scanner and the batteries
separately. This will keep the batteries in good condition for future use.
separately. This will keep the batteries in good condition for future use.
CHARGING THE BATTERY
The battery may not be charged to full for shipment. For first receive the package, it is
better to charge the battery to full before using the scanner. For 1664, use the Direct
better to charge the battery to full before using the scanner. For 1664, use the Direct
USB cable to connect the scanner to PC for charging. It takes approximately 4 hours to
charge the battery to full. Refer to
charge the battery to full. Refer to
1.13 Using Direct USB Cable
.
Note: Battery charging stops when the temperature drops below 0°C or exceeds 40°C. It
is recommended to charge the battery at room temperature (18°C to 25°C) for
optimal performance.
optimal performance.
1) Install the battery to 1664.
2) Connect 1664 to host computer or notebook via the USB cable.
3) The scanner LED will be flashing red during charging.
2) Connect 1664 to host computer or notebook via the USB cable.
3) The scanner LED will be flashing red during charging.
When the charging is done, the LED will turn off.
When charging error occurs, the LED will turn solid red. For example, a bad or
missing battery issue occurs.
When charging error occurs, the LED will turn solid red. For example, a bad or
missing battery issue occurs.