CipherLab Co. Ltd. 3656CRADLE Manuel D’Utilisation
228
Enter Setup
1560/1562 Series Barcode Scanner
User Guide
UPGRADING
UPGRADING
UPGRADING
UPGRADING 3656
3656
3656
3656 CRADLE
CRADLE
CRADLE
CRADLE USB BRIDGE FIRMWARE
USB BRIDGE FIRMWARE
USB BRIDGE FIRMWARE
USB BRIDGE FIRMWARE
1)
Connect the USB cable between 3656 CRADLE and your computer.
For USB Virtual COM, you may need to install its driver first!
2)
Connect the power supply cord from 3656 CRADLE to a proper power outlet.
3)
Refer to
3.1.1 Connect to
for the target scanner to connect to 3656 CRADLE.
Read the “Set Connection” label first, and then the “Serial Number” label. Both labels
can be located at the back of 3656 CRADLE.
can be located at the back of 3656 CRADLE.
4)
Read the following barcodes in sequence to configure the scanner to use USB Virtual
COM as download interface.
Enter Setup
Activate 3656 CRADLE
USB Virtual COM
Update
Note: You can download USB Bridge firmware via USB Virtual COM only!
5)
Read the following barcodes in sequence for 3656 CRADLE to enter the download
mode. The Communication LED on 3656 CRADLE will be flashing red to indicate it is
ready for downloading.
ready for downloading.
Enter Setup
Download 3656 CRADLE
USB Bridge Firmware
6)
Run the download utility “ProgLoad.exe” on your computer.
Kernel Program
Kernel Program
Kernel Program
Kernel Program
User Program
User Program
User Program
User Program
K3656 CRADLE Bridge_V*.shx
STD3656 CRADLE Bridge_V*.shx