Truth Hardware 4353 Manuel D’Utilisation
Forced Re-initialization:
F
Motor
Unit
Unit
Mode
Open
Close
When an error is noted in the operation of the motor unit (indicated by a Flashing
RED light on the wall plate or status indicator), the unit can be “Reset” by forcing
a re-initialization via the remote control.
1) Shut off the power* to the unit for 20 seconds. Upon reapplication of
power the unit should automatically close and stop.
2) Verify motor operation at this point, since cycling the power may correct
some problems.
3) Using the “Unit” key select the number which you programmed into the
control unit for the selected window or skylight. Note: A Reset cannot be
activated in the “All” Unit setting.
activated in the “All” Unit setting.
4) Using the “Mode” key select the “Motor” function.
5) Press both the “Unit” and “Mode” keys down simultaneously and hold
5) Press both the “Unit” and “Mode” keys down simultaneously and hold
them until the “Motor” icon on the display blinks twice. Watch to be sure
the Unit Code does not change during the button press. If it does you will
have to return to step 3.
the Unit Code does not change during the button press. If it does you will
have to return to step 3.
6) The selected unit should begin to run through a full open and closed cycle
during which a Red light should be seen at the wall switch plate or status
indicator. Watch the unit for obstructions or other problems during this
procedure. Take action to correct hardware or window/skylight related
problems as necessary.
indicator. Watch the unit for obstructions or other problems during this
procedure. Take action to correct hardware or window/skylight related
problems as necessary.
6) Repeat this procedure from step 3) until the problem is resolved.
*Power interruption is most easily accomplished by shutting off the specific
breaker at the homes fuse or power distribution panel.
Press Unit & Mode
buttons together and
hold for “Reset”
buttons together and
hold for “Reset”