HydroPoint data systems inc. WT008 Manuel D’Utilisation
Reading from left to right, the lower line of the display shows:
•
Int 05
Watering day Interval
•
To Go 02
Number of Days to next Water Day
•
Soak 10
Soak time
5.
Turn the Upper Line dial to “REVIEW the next Station(s).”
If you hold down the “COPY” button, the display will look like
this:
this:
Reading from left to right, the upper line of the display shows:
•
STA 03
Station Number
•
12.0 MIN
Length of cycle
•
06X
Number of cycles
•
U-NO
Program Mode
Note:
The examples shown are just part of a larger set of displays
that can occur as the schedules and programming change.
Adjusting
The ADJUST feature is for tweaking any stations running in the
“Fully Automated” mode. The ADJUST feature can increase or
decrease a station’s run time from the automatically calculated run
time.
“Fully Automated” mode. The ADJUST feature can increase or
decrease a station’s run time from the automatically calculated run
time.
*Note: Use ADJUST on any Stations that are continually wetter or
drier than desired.
drier than desired.
The ADJUST function should not be confused with or compared to
the Water Budget feature seen in other controllers.
the Water Budget feature seen in other controllers.
In the “Fully Automated” mode and the “User Programmed—With
ET” mode, the HydroPoint ET Everywhere Service Broadcast
automatically modifies the irrigation schedule to respond to current
water requirements based on actual weather.
ET” mode, the HydroPoint ET Everywhere Service Broadcast
automatically modifies the irrigation schedule to respond to current
water requirements based on actual weather.
STA 03 12.0 MIN 06X U-NO
Int 05 To Go Soak10
Programming Your WeatherTRAK ET Plus
57
Note:
If the “Hi ET Start Time” is used for a given day, then Hi
ET will replace the 10% field and the percent adjust will not be
shown.
shown.
3.
Turn the Upper Line dial to “REVIEW the next Station(s).”
If you are using “User Programmed—With ET,” the display will
look like this:
look like this:
Note:
The Lower Line dial is not used with User Program modes.
Reading from left to right, the upper line of the display shows:
•
•
STA 02
Station Number
•
15.2 MIN
Length of cycle
•
02X
Number of cycles
•
U-ET
Program Mode
Reading from left to right, the lower line of the display shows:
•
•
Wk1: -M-W—S
Watering days for Week 1 (current week)
•
Soak 0
Soak time
4.
Turn the Upper Line dial to “REVIEW the next Station(s).”
If you are using “User Programmed—No ET, “ the display will
look like this:
look like this:
Reading from left to right, the upper line of the display shows:
•
STA 03
Station Number
•
12.0 MIN
Length of cycle
•
06X
Number of cycles
•
U-NO
Program Mode
STA 03 12.0 MIN 06X U-NO
Int 05 To Go Soak10
STA 02 15.2 MIN 06X U-NO
Wk1:-M-W-S Soak 0
Programming Your WeatherTRAK ET Plus
56