WELINK PS-3500N Manuel D’Utilisation
INTRODUCTION
Your Paging System has the following capabilities:
• 2-Watts effective radiated power with approximately 1-mile open field range
• Operating Frequency 450~470 MHz
• Industry standard protocol covering the full range of paging functions
• PS-3500N controlled automatic switching between tone/vibe only, numeric, and alphanumeric
paging message formats, including multiple tone/vibe cadences
• PS-3500N controlled automatic switching between 512, 1200, and 2400 bps RF data rates
• Optional unique paging transmitter IDs available for use by VARs/Distributors
• Communications protocol designed to ensure reliable communications No paging receiver
database programming is required within the paging transmitter. The unique communications
protocol in the paging transmitter allows you to operate the transmitter with an unlimited quantity
of paging receivers.
protocol in the paging transmitter allows you to operate the transmitter with an unlimited quantity
of paging receivers.
EQUIPMENT SETUP
Keypad Sending Unit:
Unwrap all sending unit components. Lock the antenna into the hole in the upper
right hand
Corner of the sending unit. Plug the power supply with the large tip into a
standard 220 outlet
and plug it into the back of the sending unit. We recommend some type of surge
suppressor on the power supply for protection. Power surges are not covered
under system warranty!
suppressor on the power supply for protection. Power surges are not covered
under system warranty!
*SMPS adaptor (Transmitter Use: DC 12V 3.5A)
System Programming:
To enter programming mode, press the “SETUP” button and enter the password “123”
followed by “enter”. If the password is accepted, the display will show “use * to scroll
to menu options”.
(Use the “
followed by “enter”. If the password is accepted, the display will show “use * to scroll
to menu options”.
(Use the “
∗
/ Menu”
key to scroll through the different menu options or press
“CANCEL” to exit the system programming menu.)
1. Set the Current Time
• At
the
“Set Current Time” menu, set the hour then press “ENTER”
key.
• And then set the minutes and press “ENTER” key.
• Use
the
“# /Select” key to select AM or PM.
• After the correct time is set, press the “ENTER” or “∗ / Menu” key to return
to the main menu or press the “CANCEL” key 2 times to exit the system
programming menu.
.
programming menu.
.
2. Set the Sleep Shutdown Time
(Factory Default : ON – 1 AM)
This system has an “ALL SLEEP” function that turns off all battery pagers (for
example, manager pagers) at once automatically.
example, manager pagers) at once automatically.