WELINK PS-3500N Manuel D’Utilisation
certain pager to remind them of a duty required of them. For example, a
buzzer can receive a page every 60 minutes to remind him to check the
restrooms.
You can assign up to 3 different pagers to be duty alert pagers.
PROGRAMMING THE DUTY PAGER
• At
buzzer can receive a page every 60 minutes to remind him to check the
restrooms.
You can assign up to 3 different pagers to be duty alert pagers.
PROGRAMMING THE DUTY PAGER
• At
the
“Duty Alert” menu, press “#/Select” key to turn the duty cycle “ON”
and press the “ENTER” key.
• Enter the duty pager number and press “ENTER” key.
• Enter the cycle time (in minutes) and press the “ENTER” key.
• Enter the numeric message.
**If you are using a numeric pager as a duty pager, the numeric message
will appear on the pager display. With this feature you make up your own
numeric codes telling the patron what each code means. (Example:
“201” message may mean clean kitchen; “123” message may mean check
bar food etc.)
will appear on the pager display. With this feature you make up your own
numeric codes telling the patron what each code means. (Example:
“201” message may mean clean kitchen; “123” message may mean check
bar food etc.)
• After setting the duty alert function, press “enter”. Display will show “Duty _
_ saved”.
• Press “CANCEL” to exit or press “ENTER” to continue entering the next
duty pager information.
7. Setting the “Out of Range”
(Factory Default: OFF)
With this feature, the pagers will play a melody when taken out of range of the
transmitter to inform the guest that they are out of range and will miss their
page. The melody will only stop, when they return back within range.
transmitter to inform the guest that they are out of range and will miss their
page. The melody will only stop, when they return back within range.
Be sure that all pagers are returned before turning out of range on or off.
TURNING THE OUT OF RANGE ON
• At
TURNING THE OUT OF RANGE ON
• At
the
“Out of Range” menu, press the “#/Select” key to turn the out of
range ON.
• Press
the
“ENTER” key 3 times. After sending the signal, all the pagers
will light up once to tell you that they received the new code.
• Press
“CANCEL” key to exit the system programming menu.
To test the pagers with out of range on, unplug the power supply, that is
connected to
the transmitter. After 45 – 60 seconds, all the pagers will play a melody
since they are not receiving a signal from the transmitter. Plug in the
power supply back into the transmitter. After a few seconds, all pagers will
stop playing the melody. Plug the power supply. The pagers are ready to
receive the page with the out of range feature turned on.
since they are not receiving a signal from the transmitter. Plug in the
power supply back into the transmitter. After a few seconds, all pagers will
stop playing the melody. Plug the power supply. The pagers are ready to
receive the page with the out of range feature turned on.
TURNING THE OUT OF RANGE OFF
• At
the
“Out of Range” menu, press “#/Select” key to turn the out of range
OFF.