SendFar Technology Co. Ltd. OAB-04004 Manuel D’Utilisation

Step 2 Modify the factory-default parameters on the web page “/General

Config/System/”, and click FINISH to save the changes.

Step 3 Modify the factory-default parameters on the web page “/General

Config/Wireless/”, and click FINISH to save the changes.

Step 4 (Optional) Modify other parameters on the web page “/General

Config/”, and click FINISH to save the changes.

Step 5 Move to page “/Utility/Administration/”, select the            Save

then Restart and then click FINISH to take effect on the previous

configuration changes.

The SF-3000 supports access to the configuration system through the use
of an HTTP Interface.

„

Before configuring SF-3000, user needs to know the IP Address assigned
to the unit. When shipped from the factory, the IP Address 192.168.5.99
was assigned to the SF-3000 by default. To start a web connection, use
http://192.168.2.1

„

However, user may change the IP Address later and cannot connect the
unit by using the default IP Address. In this case, it is a must to identify the
SF-3000 current IP Address before configuring. To identify the IP Address,
user can use the serial port (refer to 

) to gain access of the current

network status.

To start a Serial Port connection by following the steps below.

Step 1 Attach the RS-232 null modem console cable (refer to 

 and

) to the RS-232 Console Port on SF-3000. Connect the

other end to a terminal or a PC running a terminal emulation
program.

Step 2 Set the terminal to 115200 baud rate, None Parity, 8 data bits, 1

Stop bit, and ANSI compatible.

Step 3 Run a terminal emulation program on PC, such as Hyper

Terminal, and set the following connection properties.

Step 3.1 Click the Start icon > Program > Accessories >

Communication > Terminal.

Step 3.2 Create a new connection file, and select a Com Port

<COM1, COM2, etc., depending on PC> with
115200bps / 8-bits / 1-stop.

Step 3.3 Click the properties icon in the Tool Bar > setting >

select Emulation terminal VT100 > ok.

Step 4 Reboot SF-3000.

Step 5 When the SF-3000 is powered up, the “Current Network Status”

will be displayed as shown below.

„

Once you identify the IP Address assigned to SF-3000, use web browser to
configure SF-3000 through the HTTP Interface. The following procedure
explains how to configure each item.

Step 1 Open your browser and enter the IP Address