SendFar Technology Co. Ltd. OAP-02002 Manuel D’Utilisation

28

2. 

Specify the Version, IP Address and Community field.

 

Select Disable, Version 1 or Version 2 to control this trap host.

- IP Address. Enter the Trap Host IP Address.

- Community. Enter the password in this field.

3. Click 

 OK . To refresh the current trap host pool.

4. 

To modify another trap host entry to the current trap host pool, repeat
step 1 through step 3.

5. 

When you have modified all the entries you need, click  FINISH .  

29

Click General Cofig, Wireless. The Wireless LAN information page Figure
4-10 appears. In here, enter the Channel (default is 1), rts Threshold
(default is 1600), frag Threshold (default is 1600), SSID (default is
wireless) and Station Name (default is ap) that are suitable for your radio
network and then you can clicked radio button to disable WEP or enable
64/128 bit WEP services (default is disable), if WEP is enabled, you must
input corresponded Default Key index and WEP Key and then click

KeyGen  to generate the WEP64 & WEP128 key patterns. After that, click

FINISH at the bottom of this page to complete the modification.

 

The factory setting is Radio Channel 1 transmitting at 2412 MHz.

The channel set appears on the screen installed on your access. Each
channel covers 22 MHz. The bandwidth for channels 1, 6, and 11 does not
overlap, so you can set up multiple access point in the same vicinity without
causing interference.

- RTS Threshold. This setting determines the packet size at which the