SendFar Technology Co. Ltd. OAP-02002 Manuel D’Utilisation
2
1.2 Locate the Access Point and Inline Power
Injector Ports
Injector Ports
z
Special
Ethernet port 1 for connecting the MIL-C-5015 style Ethernet
Cable
z
Special
serial port 2 for connecting the MIL-C-5015 style RS-232
console port cable
z
Grounding
port
3.
z
Special N-Type connector 4 for connecting the antenna or RF cable.
z
Power & Data output port 5 for connecting the other of the MIL-C-
5015 style Ethernet Cable
5015 style Ethernet Cable
z
Data input port 6 for connecting the Ethernet Cable to a Hub Switch
Router or a PC.
Router or a PC.
3
1.3 Installing the Antennas
Step 1:
With the unit powered off, attach the dipole antenna to the antenna
connector as shown in Figure 1.3.
NOTE: Do not over-tighten; finger tight is sufficient. Position the antenna
vertically for best omni-directional signal reception.
vertically for best omni-directional signal reception.
Figure 1.3.
Before installing your WLAN system, we recommend that you test the
Access Point using the dipole antenna included in your package. Once
testing is completed, install your Access Point for use with the appropriate
antenna for your application.
Access Point using the dipole antenna included in your package. Once
testing is completed, install your Access Point for use with the appropriate
antenna for your application.
1.4 Installing the Console Port Cable
Step 2: Attach the Console Port cable to the Serial Port. Attach the other
cable end to the Serial Port on a PC running a terminal emulation program,
cable end to the Serial Port on a PC running a terminal emulation program,