SendFar Technology Co. Ltd. OAP-04003 Manuel D’Utilisation
14
3.2
Configure the AP
The AP can be configured into four operation modes:
1. Outdoor Wireless Bridge
2. Outdoor Wireless Router with PPPoE Ethernet connection
3. Outdoor Wireless Router with dynamic IP address Ethernet
4. Outdoor Wireless Router with static IP address Ethernet
2. Outdoor Wireless Router with PPPoE Ethernet connection
3. Outdoor Wireless Router with dynamic IP address Ethernet
4. Outdoor Wireless Router with static IP address Ethernet
The AP is shipped with default configuration is as a bridge between an
Ethernet and wireless network. Users simply need to attach the AP to your
wired LAN. If users would like to configure the AP, please refer to the
following procedures.
Ethernet and wireless network. Users simply need to attach the AP to your
wired LAN. If users would like to configure the AP, please refer to the
following procedures.
The web user interface can be grouped into Quick setup, Basic
Configuration, Advanced Configuration and Utility as shown in Figure 3-3.
The left frame contains, in a tree structure, the contents of the AP web
configuration interface. Move through the tree by clicking on an icon to
expand or collapse the tree. The nodes on the tree represent web pages that
allow you to view and modify the parameters of the AP.
Configuration, Advanced Configuration and Utility as shown in Figure 3-3.
The left frame contains, in a tree structure, the contents of the AP web
configuration interface. Move through the tree by clicking on an icon to
expand or collapse the tree. The nodes on the tree represent web pages that
allow you to view and modify the parameters of the AP.
If users want to connect multiple wireless computers to a broadband (ADSL
or Cable) modem or an Ethernet switch to surf the Internet, you need to
configure the AP as a broadband wireless router to share a single IP
address with the multiple wireless computers as described as follows.
or Cable) modem or an Ethernet switch to surf the Internet, you need to
configure the AP as a broadband wireless router to share a single IP
address with the multiple wireless computers as described as follows.
Figure 3-3
15
3.2.1 Configure the AP as a Bridge
Configure TCP/IP parameters
1. Click Advanced Config, select Bridging, and then click Enable for
Bridge Function as shown in Figure 3-4. In the Bridging Parameter
window, enter the IP Address (default is 192.168.2.1) and Subnet
Mask (default is 255.255.255.0) that are suitable for your network
domain. After that, click FINISH at the bottom of this page to complete
the modification of this page.
window, enter the IP Address (default is 192.168.2.1) and Subnet
Mask (default is 255.255.255.0) that are suitable for your network
domain. After that, click FINISH at the bottom of this page to complete
the modification of this page.
Figure 3-4