Справочник Пользователя для SendFar Technology Co. Ltd. OAP-04003

 

 

14

The AP can be configured into four operation modes: 

1.  Outdoor Wireless Bridge 
2.  Outdoor Wireless Router with PPPoE Ethernet connection 
3.  Outdoor Wireless Router with dynamic IP address Ethernet 
4.  Outdoor Wireless Router with static IP address Ethernet 

The AP is shipped with default configuration is as a bridge between an 
Ethernet and wireless network. Users simply need to attach the AP to your 
wired LAN. If users would like to configure the AP, please refer to the 
following procedures.  

The web user interface can be grouped into Quick setup, Basic 
Configuration, Advanced Configuration and Utility as shown in Figure 3-3. 
The left frame contains, in a tree structure, the contents of the AP web 
configuration interface. Move through the tree by clicking on an icon to 
expand or collapse the tree. The nodes on the tree represent web pages that 
allow you to view and modify the parameters of the AP.  

If users want to connect multiple wireless computers to a broadband (ADSL 
or Cable) modem or an Ethernet switch to surf the Internet, you need to 
configure the AP as a broadband wireless router to share a single IP 
address with the multiple wireless computers as described as follows. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

 

15

 

1.  Click Advanced Config, select Bridging, and then click Enable for 

Bridge Function as shown in Figure 3-4. In the Bridging Parameter 
window, enter the IP Address (default is 192.168.2.1) and Subnet 
Mask (default is 255.255.255.0) that are suitable for your network 
domain. After that, click FINISH at the bottom of this page to complete 
the modification of this page.