Broadcom Corporation BRCM1005-D Manuel D’Utilisation

156

Adding and Replacing Parts

www

.dell.com | support.dell.com

FILE LOCATION:  S:\SYSTEMS\Pebble\UG\A00\English\r_r.fm

D E L L   C O N F I D E N T I A L   –   P R E L I M I N A RY   1 / 2 9 / 0 3   –   F O R   P R O O F   O N LY

Adding Memory

You can increase your computer memory by installing memory modules on 
the system board. See "

" for information on the memory 

supported by your computer. Install only memory modules that are 
intended for your computer.

 NOTE: Memory modules 

purchased from Dell are 
covered under your 
computer warranty.

  CAUTION: Before working inside your computer, read the safety 

instructions in your 

System Information Guide

.

1

Ensure that the work surface is flat and clean to prevent scratching the 

computer cover.

2

Save and close any open files, exit any open programs, and then shut 

down the computer.

3

If the computer is connected to a docking device (docked), undock it. 

See the documentation that came with your docking device for 

instructions.

4

Disconnect the computer from the electrical outlet.

5

Wait 10 to 20 seconds, and then disconnect any attached devices.

6

Remove any installed PC Cards and the battery.

 NOTICE: Handle components and cards by their edges, and avoid touching 

pins and contacts. Ground yourself by touching a metal connector on the back 
of the computer. Continue to ground yourself periodically during this 
procedure.

7

Continue to the appropriate section:
• "

• "

"

Installing a Memory Module Under the Memory Module/Modem 

Cover

1

Turn the computer over, loosen the captive screws on the memory 

module/modem cover, and then remove the cover.