Broadcom Corporation BRCM1005-D Manuel D’Utilisation

Adding and Replacing Parts

163

FILE LOCATION:  S:\SYSTEMS\Pebble\UG\A00\English\r_r.fm

D E L L   C O N F I D E N T I A L   –   P R E L I M I N A RY   1 / 2 9 / 0 3   –   F O R   P R O O F   O N LY

9

Connect the modem cable to the modem.

 NOTICE: The cable connectors are keyed for correct insertion; do not force 

the connections.

10

Align the modem with the screw hole, and press the modem into the 

connector on the system board.

11

Install the screw to secure the modem to the system board.

12

Replace the modem cover.

Replacing the Keyboard

  CAUTION: Before working inside your computer, read the safety 

instructions in your 

System Information Guide

.

1

Ensure that the work surface is flat and clean to prevent scratching the 

computer cover.

2

Save and close any open files, exit any open programs, and then shut 

down the computer.

3

If the computer is connected to a docking device (docked), undock it. 

See the documentation that came with your docking device for 

instructions.

4

Disconnect the computer from the electrical outlet.

5

Wait 10 to 20 seconds, and then disconnect any attached devices.

6

Remove any installed PC Cards and the battery.

 NOTICE: Handle components and cards by their edges, and avoid touching 

pins and contacts. Ground yourself by touching a metal connector on the back 
of the computer. Continue to ground yourself periodically during this 
procedure.

7

Open the display approximately 180 degrees.

8

Use a small flat-blade screwdriver or plastic scribe to lift the notched 

right edge of the center control cover, and pry the cover loose from the 

bottom case. 

9

Remove the two screws from the top of the keyboard.

10

Use the pull tab to pull the keyboard up and out (towards the display) 

of the bottom case.