Broadcom Corporation BRCM1020 Manuel D’Utilisation
144
Adding and Replacing Parts
FILE LOCATION: C:\Projects\Spears\SpearsHTML\parts.fm
DELL CONFIDENTIAL – PRELIMINARY 7/18/07 - FOR PROOF ONLY
Replacing the Keyboard
1 Slide the keyboard cable into the keyboard connector.
2 Rotate the keyboard connector latch to secure the cable.
3 Hook the tabs along the front edge of the keyboard into the palmrest.
4 Press on the right edge near the top to snap the keyboard into place.
5 Replace the two screws on the top of the keyboard.
2 Rotate the keyboard connector latch to secure the cable.
3 Hook the tabs along the front edge of the keyboard into the palmrest.
4 Press on the right edge near the top to snap the keyboard into place.
5 Replace the two screws on the top of the keyboard.
Memory
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
You can increase your computer memory by installing memory modules on
the system board. See "Specifications" on page 165 for information on the
memory supported by your computer. Install only memory modules that are
intended for your computer.
the system board. See "Specifications" on page 165 for information on the
memory supported by your computer. Install only memory modules that are
intended for your computer.
NOTE:
Memory modules purchased from Dell are covered under your computer
warranty.
Your computer has two user-accessible SODIMM sockets, DIMM A and
DIMM B, accessed from the bottom of the computer.
DIMM B, accessed from the bottom of the computer.
NOTICE:
If you need to install memory modules in two connectors, install a
memory module in the connector labeled “DIMMA” before you install a module in
the connector labeled “DIMMB.”
the connector labeled “DIMMB.”
Removing Memory Module
The memory modules are located under the memory module cover on the
bottom of the computer.
bottom of the computer.
1 Follow the procedures in "Before You Begin" on page 135.
2 Turn the computer upside-down, loosen the five captive screws on the
2 Turn the computer upside-down, loosen the five captive screws on the
cover (see "Bottom View" on page 30), and remove the cover.