Newcont Electronic Co. Ltd. NTP-6309 Manuel D’Utilisation

Page de 20
6. Press the                           button to return to the STANDBY mode.
NOTE: The date and time will automatically set, if you have subscribed to the Caller ID 
             service from your local telephone company.
D. RINGER VOLUME
This function enables you to adjust the ringer volume from HI,  LOW  and OFF as 
desired.
1. Press the                           button and hold down.
2. Press the TELEPHONE  KEYPAD             button.
3. Press the                       button.
4. Press the SCROLL UP         OR DOWN         button to adjust the ringer volume 
    suitable for your convenience. HI is the preset ringer volume.
5. Press and hold down the                     button.
6. Press the                           button to return to STANDBY mode.
E. LCD CONTRAST 
This unit enables you to select 8 brightness levels for the Large LCD Screen.
 
 
                           
 
 
and hold down
1. Press the
button 
.
2. Press the TELEPHONE KEYPAD             button.
3. Press the                      button.
4. Press the SCROLL UP         OR DOWN        button to adjust the brightness of the
    LCD Screen. Level 6 is the preset brightness.
5. Press and hold down the                     button until a confirmation"beep" is heard.
6. Press the                           button to return to STANDBY mode.
F. AREA CODE
At any time during options programming of a home area code where 7-digit is using
for ease of call back and others features cdo not program if you use 10-digit to call
numbers in your area.
1. Press the                           button and hold down.
2. Press the TELEPHONE  KEYPAD             button.
3. Press the                       button.
Caller ID System Operation
21
EDIT
/FLASH
/ VOICE MAIL
/ VOICE MAIL
/ VOICE MAIL
/ VOICE MAIL
/ VOICE MAIL
/ VOICE MAIL
SAVE
/RE/PA
SAVE
/RE/PA
EDIT
/FLASH
EDIT
/FLASH
4
Safety Instructions
 
      E. If the telephone has been dropped or the case has been damaged.
      F. If the telephone exhibits a distinct change in performance.
16. Never install telephone wiring during a lighting storm.
17. Never install telephone jacks in wet locations unless the jack is specifically designed
      for wet locations.
18. Never touch uninsulated  telephone wires or terminals unless the telephone line has
       been disconnected at the network interface.
19. Use caution when installing or modifying telephone lines.
1. Use only the following type and size BATTERY PACK: 
    Cordless Telephone BATTERY PACK
    3.6V, 600mAh.
    Ni-MH BATTERY 
 
2. Do not dispose of the BATTERY PACK in a fire. It may explode. Check with local codes
    for possible special disposal instructions.
3. Do not open or mutilate the BATTERY PACK. Released electrolyte from a BATTER 
    PACK  is corrosive and may cause damage to the eyes or skin. Electrolyte may be 
    toxic if swallowed.
4. Exercise care in handling the BATTERY PACK to prevent shorting the BATTERY PACK
    with conductive material such as rings, bracelets and keys. The BATTERY PACK or
    conductor may overheat and cause burns.
5. Charge the BATTERY PACK provided with (or identified for use with) this telephone  
    only in accordance with the instructions and limitations specified in this manual.
6. Observe proper polarity orientation between the BATTERY PACK and BATTERY 
    CHARGER.
                                  
SAVE THESE INSTRUCTIONS.
ATTENTION:
The telephone  that you have purchased contains a rechargeable BATTERY PACK. The  
BATTERY PACK  is recyclable. At the end of its useful life, under various state and local 
laws, it may be illegal to dispose of this battery into the municipal waste  stream. Check 
with your local solid waste officials for details in your area for recycling options or proper 
disposal.
                                          
Battery Safety
CAUTION:
Danger of explosion if the BATTERY PACK is incorrectly replaced. Replace
only with the same or equivalent type.To reduce the risk of fire or personal 
injury, read and follow these instructions: