Vocera Communications B2000 Manuel D’Utilisation
Getting Started ··· 15
Getting Started
If this is the first time you are using a Vocera badge, you can get started
right away by following these simple steps:
right away by following these simple steps:
1.
Charge the battery, if necessary.
New batteries must be charged before use. If the badge has already
been used by someone else, check the battery level indicator on the
badge display to make sure the battery has sufficient power.
been used by someone else, check the battery level indicator on the
badge display to make sure the battery has sufficient power.
See Maintaining Your Badge on page 57 for other ways to
determine whether the battery needs charging and for instructions
on how to charge the battery with or without the badge.
determine whether the battery needs charging and for instructions
on how to charge the battery with or without the badge.
2.
Choose the lanyard, pocket clip, or universal clip attachment, and
connect it to the badge. Attachments need to be connected prior to
battery installation.
connect it to the badge. Attachments need to be connected prior to
battery installation.
3.
Install the battery. To do this, slide the holes in the top of the battery
over the small pegs at the top of the badge’s battery compartment,
and then press down gently to seat the battery.
over the small pegs at the top of the badge’s battery compartment,
and then press down gently to seat the battery.
Lanyard
Pocket Clip
Universal Clip
Lanyard
Pocket Clip
Universal Clip