Rehabtronics Inc. HSST1 Manuel D’Utilisation
40
ELECTRODES Cleaning & Maintenance
Between uses, ELECTRODES can be maintained as follows:
1. Disconnect ELECTRODES from the GARMENT.
2. Rinse ELECTRODES with clean water.
3. Squeeze out excess water, and allow ELECTRODES to air-dry.
4. When not in use, store the ELECTRODES in a dry, ventilated area.
CAUTION: Do not use soaps, detergents, or other chemical cleaners on the ELECTRODES.
Doing so may cause skin-irritation, or affect stimulation.
Doing so may cause skin-irritation, or affect stimulation.
CAUTION: Do not store ELECTRODES wet. Allow the ELECTRODES to fully air-dry prior to
storing.
storing.
The ELECTRODES are intended to be replaced regularly to prevent bacterial or other buildup, or
degradation of materials. ELECTRODES should be replaced in either of the following cases:
degradation of materials. ELECTRODES should be replaced in either of the following cases:
1. If there is significant discoloration, bad odors, or any noticeable separation of materials; or,
2. After two (2) weeks of daily use.
2. After two (2) weeks of daily use.
CAUTION: Inspect ELECTRODES prior to use. Damaged or dirty electrodes will affect
stimulation efficacy, and hence should be replaced regularly.
stimulation efficacy, and hence should be replaced regularly.
For re-ordering information see “Contact & Reordering Information” at the end of this manual.