3e Technologies International Inc. 523E-900 Manuel D’Utilisation
AirGuard WiMesh 3e-
523 Series User’s Guide
Copyright
2015 Ultra Electronics, 3eTI
October 2015
89
29000169-005 Revision C1
3.1.5 Reset Button
The reset button is located behind the Phillips (cross-tip) screw on the top side of the unit (Figure 83).
Remove the screw to access the reset button. To reset the unit, use a small screw driver and perform the
following:
Remove the screw to access the reset button. To reset the unit, use a small screw driver and perform the
following:
1. Push in and hold the reset button for five seconds. Holding the button for more than five (5)
seconds but less than 10 does a reset. Removing power, or going through the web interface
are usually a better ways to reset, when possible. If you hold the button too long, you could
factory default the unit by mistake, and wipe out your configuration.
are usually a better ways to reset, when possible. If you hold the button too long, you could
factory default the unit by mistake, and wipe out your configuration.
2. If you continue to hold the button, after 20 seconds the unit will be reset to the factory default.
3. Make sure you reinstall the screw with gasket after using the reset button to keep water out of
the unit.
Figure 83 - Reset button