Extreme networks OAP36C Manuel D’Utilisation
WS-AP3660 Power Supply Installation Procedures
Installation
Enterasys Wireless Outdoor WS-AP3660 Installation Guide
2-11
Ground Connection
1.
The ground connection for the WS-AP3660 is located on the rear of the device. Attach a
ground to earth cable to one of two grounding terminals using one ground screw (see
ground to earth cable to one of two grounding terminals using one ground screw (see
).
Figure 2-8
WS-AP3660 Grounding Terminals
Power Connections
The WS-AP3660 can be powered in one of the following ways:
•
Power over Ethernet (PoE)
Power is provided to the LAN port of the WS-AP3660 with a PoE injector. The PoE injector
must be 802.3at compliant and is not provided with the WS-AP3660.
must be 802.3at compliant and is not provided with the WS-AP3660.
•
Power by external power supply
An external 12VDC power supply (WS-PS3660-MR) can be purchased to power the
WS-AP3660. For more information on the installation process, see
WS-AP3660. For more information on the installation process, see
below.
WS-AP3660 Power Supply Installation Procedures
These procedures describe how to attach the mounting bracket to the WS-AP3660 Power Supply,
how to mount the power supply outside (either a wall or pole), and how to attach the relevant
cables.
how to mount the power supply outside (either a wall or pole), and how to attach the relevant
cables.
1
Grounding terminals (2)
Note: The RJ45 connector used for providing PoE to the WS-AP3660 must be contained within a
waterproof adapter assembly before being installed. For more information, see “
waterproof adapter assembly before being installed. For more information, see “
Electrical Hazard: This product should be installed and serviced by a qualified licensed technician,
electrician, or electrical maintenance person familiar with its operation and the hazards involved.
electrician, or electrical maintenance person familiar with its operation and the hazards involved.