Mobiltex Data Ltd 03579 Manuel D’Utilisation
Figure 6 - OVPC2G Side View - Antenna Port
5.3 Expansion Serial Port
The expansion serial port is a logic-level serial port complete with additional user configurable I/O. This port is not
externally accessible and is intended for use with optional devices installed within the OVPC2G housing. Contact
Mobiltex for application guidance prior to utilizing this connector.
externally accessible and is intended for use with optional devices installed within the OVPC2G housing. Contact
Mobiltex for application guidance prior to utilizing this connector.
6. General use guidelines
1. The OVPC2G must only be used when installed within Mobiltex holster part number MOB-H7500SW-FX6.
2. Ensure that the MMCX connector is securely connected with the holster’s internal antenna feed cable prior to
2. Ensure that the MMCX connector is securely connected with the holster’s internal antenna feed cable prior to
powering the device.
3. Ensure that the battery is fully charged prior to use. In the event that the battery fails to charge, it cannot be
serviced or replaced by the end-user. Contact Mobiltex Data Ltd. for service information.
4. To turn on the OVPC2G, remove the OVPC2G from the holster and slide the switch to the “on” (right-most)
position. Re-install the OVPC2G in the holster prior to use.
5. The LED indicators will automatically turn-off during normal operation. To momentarily turn-on these
indicators, tilt the bottom of the holster above horizontal. Hold the holster in this position until the LED
indicators turn-on. The LEDs will automatically turn-off again after a few moments to conserve battery power.
indicators turn-on. The LEDs will automatically turn-off again after a few moments to conserve battery power.
6. The OVPC2G has two modes of low-battery shutdown. In the first mode, the device will commence an orderly
software shutdown when the battery has reached a pre-determined low limit. In the second mode, hardware
circuitry inhibits start-up and operation of the device when the battery voltage is too low for proper operation.
circuitry inhibits start-up and operation of the device when the battery voltage is too low for proper operation.
Once power is applied, use of the OVPC2G is determined by end-user application software.
MOBILTEX DATA LTD.
TITLE:
Mobiltex OVPC2G Hardware User’s Manual
Calgary, Alberta
DOCUMENT NO.:
OVPC2G-MAN-001
SHEET:
9 of 10
REV:
002