Continental Automotive GmbH KESSY Manuel D’Utilisation
FCC ID: KR5KESSY
File: S\Postzula\VW\Kessy\Usa_Canada\funktionsbeschreibung_e
Page 9
Operation:
The four-level rotary switch in the test box enables selection which antennas are
driven.
driven.
The following combinations are possible:
1. Backlite shelf antennas (antenna group 1)
2. Interior antennas (antenna group 2)
3. Door handle antennas (antenna group 3)
4. Bumper antennas (antenna 4)
Before changing over to a different antenna, the testing staff should change the
master switch on the test box to "OFF", and subsequently to "ON".
master switch on the test box to "OFF", and subsequently to "ON".
Select the desired mode via the switch "modulation – no modulation". To change the
mode, turn the master switch to "OFF".
mode, turn the master switch to "OFF".
In the "modulation" mode, a telegram modulated to the carrier frequency is emitted.
The modulation-free carrier frequency is sent in the mode "no modulation".
The modulation-free carrier frequency is sent in the mode "no modulation".
Turn the main switch on the test box to "ON". Thus, the selected antenna will transmit
(telegrams with a duration of approx. 40ms at intervals of 500ms), until the switch is
turned back to "OFF".
(telegrams with a duration of approx. 40ms at intervals of 500ms), until the switch is
turned back to "OFF".
This procedure does not correspond to the normal operating mode of the an-
tenna drivers! This procedure is only used to simplify emission measurements.
tenna drivers! This procedure is only used to simplify emission measurements.