Garnet Systems Co Ltd GAE3020 Manuel D’Utilisation
GARNET GAE-3020
14
ppp 1 welogin fred password chap
ppp 1 enable
ppp 1 enable
•
••
•
Save the configuration and reboot the system. This is necessary when
configuring the system from the console, because the following command can
only operate on router interfaces which have already been created.
only operate on router interfaces which have already been created.
config save
restart
restart
•
••
•
Enable forwarding between the router interfaces:
ip relay all
•
••
•
Save the configuration and reboot the system:
config save
restart
restart
2.10 NAT
NAT can be used with IPoA routing or PPP routing. NAT has to be enabled on the
router interface towards the service provider.
The following command enables NAT on a router interface.
router interface towards the service provider.
The following command enables NAT on a router interface.
ip nat add <interface name>
For the IPoA example previously described the command would be:
ip nat add ipoa
For the PPP example previously described the command would be:
ip nat add ppp_device
2.11 DHCP Server
DHCP can be used to assign IP addresses to PCs connected on the Ethernet
interface of the Client Access Device, as long as the Client Access Device has
been assigned an IP address. In addition to the commands shown in the next
sections, use the following command to get information on all of the DHCP
Server commands:
interface of the Client Access Device, as long as the Client Access Device has
been assigned an IP address. In addition to the commands shown in the next
sections, use the following command to get information on all of the DHCP
Server commands:
dhcpserver help