Z Com Inc ZC3625-55V04 Manuel D’Utilisation

 

Chapter 4 Configuration 

Page 22

The units to be installed should be configured before physical installation. During this process, 

the installer can set the unit’s IP address to the one within desired address range and set each 

unit up with the MAC address of its peer unit ready to establish a wireless link. It is 

recommended that this procedure be carried out on the bench before physical installation.  

This chapter describes how to configure your bridge for the first time. You can use the bridge’s 

web-based interface to complete the initial configuration. 

If you are configuring the bridge locally (without connecting its power injector to a wired LAN), 

connect a PC to the power injector’s Ethernet port using a Category 5 Ethernet cable. 

1.  Assign a static IP address to your PC which is in the same network segment with the 

wireless bridge. As the default IP address of this unit is 192.168.1.1, you may choose 

from 192.168.1.2 to 192.168.1.254. 

2.  Test the link status between your PC and the wireless bridge. Start a command prompt 

and execute a continuous ping command “ping 192.168.1.1 –t”. If ping to the wireless 

bridge is successful (as shown below), open Internet browser and enter the bridge’s IP 

address in the address filed and press Enter.