ADC Telecommunications Inc. F0694-011 Manuel D’Utilisation

7-6

CONFIDENTIAL

Follow this procedure before installing Fusion Wideband equipment:

Verify the number of packages received against the packing list.

Check all packages for external damage; report any external damage to the ship-
ping carrier. If there is damage, a shipping agent should be present before you 
unpack and inspect the contents because damage caused during transit is the 
responsibility of the shipping agent.

Open and check each package against the packing list. If any items are missing, 
contact ADC customer service (refer to Section 7.2.2 on page 7-4).

If damage is discovered at the time of installation, contact the shipping agent.

3

Floor Plans

Installation location of equipment clearly marked

System Design

Used to verify frequency bands after installation

Power available:

Fusion Wideband Main Hub (AC)
Fusion Wideband Expansion Hub (AC)
To RAU (DC)

Fusion Wideband Main Hub (DC)
Fusion Wideband Expansion Hub (DC)

Hub’s power cord is 2 m (6.5 ft) long.
100/240V, 1A, 50–60 Hz
100/240V, 6A, 50-60 Hz
54V (from the Hub)

38–64VDC, 2.5A
38–64VDC, 14A

Rack space available
(Main and Expansion Hub)

89 mm (3.5 in.) high (2U)

Wallmount Fusion Wideband Main Hub

Hub must be mounted on 3/4” plywood backboard.

Clearance for air circulation:

Fusion Wideband Main or Expansion Hub
RAU

76 mm (3 in.) front and rear, 51 mm (2 in.) sides
76 mm (3 in.) all around

Suitable operating environment:

Fusion Wideband Main or Expansion Hub

RAUs

Indoor location only
0° to +45°C (+32° to +113°F)
5% to 95% non-condensing humidity

–25° to +45°C (–13° to +113°F)
5% to 95% non-condensing humidity

Donor Antenna

Installed, inspected; N-male to N-male coaxial cable to lightning arrestor/surge 
suppressor

Lightning Arrestor or 
Surge Suppressor

Installed between roof-top antenna and repeater; N-male to N-male 50 Ohm coax-
ial cable and outdoor cables longer than 140 feet.