Hewlett Packard Enterprise AP3750 Manuel D’Utilisation
15
5
If you are using an external antenna, insert the antenna cable into the antenna
connector on the access point.
connector on the access point.
6
Plug the Category 5 cable into the access point.
5
Connecting the Access Point to a Switch
3Com recommends that you install and configure the 3Com Wireless LAN Switch before installing the
access point. If the switch is already installed and configured for the access point, you can immediately
verify the cable connection when you plug the cable into the access point.
access point. If the switch is already installed and configured for the access point, you can immediately
verify the cable connection when you plug the cable into the access point.
You can connect the access point directly to a 3Com Wireless LAN Switch port or indirectly to
3Com Wireless LAN switches through an intermediate Layer 2 or Layer 3 network. In either case, use
Category 5 cable with straight-through signaling for each access point connection.
3Com Wireless LAN switches through an intermediate Layer 2 or Layer 3 network. In either case, use
Category 5 cable with straight-through signaling for each access point connection.
•
To connect the access point directly to a 3Com Wireless LAN Switch, configure the switch port
as an AP3750 managed access point and then insert the cable into the switch and verify the
link.
as an AP3750 managed access point and then insert the cable into the switch and verify the
link.
•
To connect the access point indirectly to a 3Com Wireless LAN Switch through the network,
configure a Distributed Access Point connection on the switch.
configure a Distributed Access Point connection on the switch.
6
Configuring the Access Point
To configure the channels, power settings, and other access point parameters, see the following:
•
“Configuring a WX Switch for Basic Service” chapter in the 3Com Wireless LAN Switch and
Controller Installation and Basic Configuration Guide.
Controller Installation and Basic Configuration Guide.
•
“Configuring MAP Access Points” chapter in the 3Com Wireless LAN Switch and Controller
Configuration Guide.
Configuration Guide.
CAUTION: If you plan to use an external antenna for the 802.11b/g or 802.11a radio, install the
antenna at least 20 cm from the access point.
antenna at least 20 cm from the access point.
WARNING: Do not connect or disconnect cables or otherwise work with the access point during
periods of lightning activity.
periods of lightning activity.
Note: You can use the CLI or 3WXM to configure an AP3750 access port or Distributed Access
Point connection. See the 3Com Wireless LAN Switch and Controller Configuration Guide or the
3Com Wireless LAN Switch Reference Manual
Point connection. See the 3Com Wireless LAN Switch and Controller Configuration Guide or the
3Com Wireless LAN Switch Reference Manual
.