Accton Technology ACCWA5001 Manuel D’Utilisation
D
O
N
O
T
C
O
P
Y
Preliminary
AP User’s Guide
•
Page 13
Subject to change without notice.
October 2001
9. Set COM port settings to 9600 Bits per second, 8 Data bits, None Parity,
1 Stop bits, and no Flow control. Click OK, and plug the AP power supply into
the power source to start the connection.
the power source to start the connection.
10. An auto-boot message appears on HyperTerminal a few seconds after the AP is
connected to the power source. Press any key to stop the auto-boot process and
follow Section 3.1.1 to load the VxWorks file over the Ethernet connection, or
Section 3.1.2 to load the VxWorks file from Flash memory.
follow Section 3.1.1 to load the VxWorks file over the Ethernet connection, or
Section 3.1.2 to load the VxWorks file from Flash memory.
2.3.1 Booting VxWorks From the Ethernet Connection to the HPC
Follow these steps to configure the AP to boot VxWorks from the Ethernet:
1. Type “c” at the command prompt to configure the AP.
2. Follow the Boot from Ethernet settings described in Table 2 to enter the
2. Follow the Boot from Ethernet settings described in Table 2 to enter the
parameters in the configuration steps.