Accton Technology ACCWA5001 Manuel D’Utilisation
D
O
N
O
T
C
O
P
Y
Preliminary
AP User’s Guide
•
Page 15
Subject to change without notice.
October 2001
2.3.2 Booting VxWorks From Flash Memory
Follow these steps to configure the AP to boot VxWorks from Flash memory. Refer to
Appendix B (“Download Software Image” section on page Error! Bookmark not
defined.) for CLI commands to load the VxWorks image file to the Flash file system, if
VxWorks does not exist in Flash memory.
Appendix B (“Download Software Image” section on page Error! Bookmark not
defined.) for CLI commands to load the VxWorks image file to the Flash file system, if
VxWorks does not exist in Flash memory.
1. At the command prompt, type “c” to enter the configuration parameters.
2. Follow the default “Boot from Flash” settings described in Table 2 to enter the
configuration parameters.
3. Enter @ to load VxWorks.