ZyXEL Communications Corporation EMG2926Q10A Manuel D’Utilisation
Chapter 22 Remote Management
EMG2926-Q10A User’s Guide
155
22.3.1 Remote Management and NAT
When NAT is enabled:
• Use the EMG2926-Q10A’s WAN IP address when configuring from the WAN.
• Use the EMG2926-Q10A’s LAN IP address when configuring from the LAN.
• Use the EMG2926-Q10A’s LAN IP address when configuring from the LAN.
22.3.2 System Timeout
There is a default system management idle timeout of five minutes (three hundred seconds). The
EMG2926-Q10A automatically logs you out if the management session remains idle for longer than
this timeout period. The management session does not time out when a statistics screen is polling.
You can change the timeout period in the Maintenance > General screen
EMG2926-Q10A automatically logs you out if the management session remains idle for longer than
this timeout period. The management session does not time out when a statistics screen is polling.
You can change the timeout period in the Maintenance > General screen
22.4 WWW Screen
To change your EMG2926-Q10A’s remote management settings, click Management > Remote
MGMT > WWW.
MGMT > WWW.
Figure 105
Management > Remote Management > WWW
The following table describes the labels in this screen.
Table 65
Management > Remote Management > WWW
LABEL
DESCRIPTION
Port
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
use the same port number in order to use that service for remote management.
Access Status
Select the interface(s) through which a computer may access the EMG2926-Q10A
using this service.
using this service.
Secured Client IP
Address
Address
Select All to allow all computes to access the EMG2926-Q10A.
Otherwise, check Selected and specify the IP address of the computer that can
access the EMG2926-Q10A.
access the EMG2926-Q10A.
Apply
Click Apply to save your customized settings.
Cancel
Click Cancel to begin configuring this screen afresh.