ZyXEL Communications Corporation EMG2926Q10A Manuel D’Utilisation
Chapter 22 Remote Management
EMG2926-Q10A User’s Guide
156
22.5
Telnet Screen
To change your EMG2926-Q10A’s remote management settings, click Management > Remote
MGMT > Telnet to open the Telnet screen.
MGMT > Telnet to open the Telnet screen.
Figure 106
Management > Remote MGMT > Telnet
The following table describes the labels in this screen.
22.6
SNMP
Simple Network Management Protocol is a protocol used for exchanging management information
between network devices. Your EMG2926-Q10A supports SNMP agent functionality, which allows a
manager station to manage and monitor the EMG2926-Q10A through the network.
between network devices. Your EMG2926-Q10A supports SNMP agent functionality, which allows a
manager station to manage and monitor the EMG2926-Q10A through the network.
The EMG2926-
Q10A supports SNMP version one (SNMPv1) and version two (SNMPv2c).
The next figure illustrates
an SNMP management operation.
Table 66
Management > Remote MGMT > Telnet
LABEL
DESCRIPTION
Port
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
use the same port number in order to use that service for remote management.
Access Status
Select the interface(s) through which a computer may access the EMG2926-Q10A
using this service.
using this service.
Secured Client IP
Address
Address
Select All to allow all computes to access the EMG2926-Q10A.
Otherwise, check Selected and specify the IP address of the computer that can
access the EMG2926-Q10A.
access the EMG2926-Q10A.
Apply
Click Apply to save your customized settings.
Cancel
Click Cancel to begin configuring this screen afresh.