ZyXEL Communications Corporation NBG2105 Manuel D’Utilisation
Chapter 3 Operation Modes
NBG2105 User’s Guide
25
Figure 6
Access Point Mode Application
3.4.1 Setting Access Point Mode
Select Access Point Mode if your device bridges traffic between clients on the same network. To set
Access Point mode:
Access Point mode:
1
Make sure the power LED is on (not blinking).
2
Slide the Operation Mode Switch to Router. See
.
3
The NBG2105 restarts after you slide the Operation Mode Switch.
4
In the Web Configuator, click Management > Operation, select AP and then click Apply
Changes.
Changes.
3.4.2 Navigation Panel
Use the sub-menus on the navigation panel to configure NBG2105 features.