ZyXEL Communications Corporation P660HNT1AV2 Manuel D’Utilisation
Chapter 9 Quality of Service (QoS)
P-660HN-Tx(A) v2 User’s Guide
130
9.3.1 Adding a QoS Queue
Click the edit icon in the Queue Setup screen to configure a queue.
Figure 53
Queue Setup: Edit
The following table describes the labels in this screen.
Interface
This shows the name of the ADSL Router’s interface through which traffic in this queue passes.
Priority
This shows the priority of this queue.
Weight
This shows the weight of this queue.
Rate Limit
This shows the maximum transmission rate allowed for traffic on this queue.
Modify
Click the Edit icon to edit the queue.
Click the Delete icon to delete an existing queue. Note that subsequent rules move up by one
when you take this action.
when you take this action.
Table 35
Network Setting > QoS > Queue
LABEL
DESCRIPTION
Table 36
Queue Setup: Edit
LABEL
DESCRIPTION
Active
Select to enable or disable this queue.
Name
Enter the descriptive name of this queue.
Interface
Select the interface to which this queue is applied.
This field is read-only if you are editing the queue.
Priority
Select the priority level (from 1 to 3) of this queue.
The smaller the number, the higher the priority level. Traffic assigned to higher priority
queues gets through faster while traffic in lower priority queues is dropped if the network is
congested.
queues gets through faster while traffic in lower priority queues is dropped if the network is
congested.
Weight
Select the weight (from 1 to 8) of this queue.
If two queues have the same priority level, the ADSL Router divides the bandwidth across
the queues according to their weights. Queues with larger weights get more bandwidth
than queues with smaller weights.
the queues according to their weights. Queues with larger weights get more bandwidth
than queues with smaller weights.
Rate Limit
Specify the maximum transmission rate (in Kbps) allowed for traffic on this queue.
OK
Click OK to save your changes.
Cancel
Click Cancel to exit this screen without saving.