ZyXEL Communications Corporation VMG1312T10C Manuel D’Utilisation
Chapter 8 Static Route
VMG1312-T10C User’s Guide
116
8.2 Configuring Static Route
Use this screen to view and configure IP static routes on the Device. Click Network Setting >
Static Route to open the following screen.
Static Route to open the following screen.
Figure 75
Network Setting > Static Route
The following table describes the labels in this screen.
8.2.1 Add/Edit Static Route
Click add new Static Route in the Routing screen or click the Edit icon next to a rule. The
following screen appears. Use this screen to configure the required information for a static route.
following screen appears. Use this screen to configure the required information for a static route.
Figure 76
Routing: Add/Edit
Table 35
Network Setting > Static Route
LABEL
DESCRIPTION
Add New Static
Route
Route
Click this to set up a new static route on the Device.
#
This is the number of an individual static route.
Destination IP
This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
always based on network number.
Gateway
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets
to their destinations.
network segment as the device's LAN or WAN port. The gateway helps forward packets
to their destinations.
Subnet Mask
This parameter specifies the IP network subnet mask of the final destination.
Interface
This is the WAN interface through which the traffic is routed.
Metric
This is the “cost” of transmission for routing purposes.
Modify
Click the Edit icon to go to the screen where you can set up a static route on the
Device.
Device.
Click the Delete icon to remove a static route from the Device.