ZyXEL Communications Corporation WAP5705 Manuel D’Utilisation

Chapter 5 Client Mode

WAP5705 User’s Guide

Use this screen to enable Wi-Fi Protected Setup (WPS) on the WAP5705. Go to Configuration > 
Wireless LAN > WPS to open the following screen.

Client Mode: WLAN > WPS 

The following table describes the labels in this screen. 

Rescan

Click this button to search for available wireless devices within transmission range and 
update this table.

Add Profile

Select a wireless device and click this button to add it to a profile.

Client Mode: WLAN > Site Survey (continued)

Client Mode: WLAN > WPS

Station Site Survey

No.

Use the radio button to select the wireless device to which you want to connect using WPS.

SSID

This displays the SSID of the wireless device.

BSSID

This displays the MAC address of the wireless device.

Signal Strength

This displays the strength of the wireless signal. The signal strength mainly depends on the 
antenna output power and the distance between your WAP5705 and this device.

Ch.

This displays the channel number used by this wireless device. 

Auth.

This displays the authentication method used by this wireless device.

Encrypt

This displays the data encryption method used by this wireless device.

Ver.

This displays the firmware version running on the wireless device.

Status

This displays Conf. (configured) when WPS has been set up on the wireless device. 

This displays Unconf. (unconfigured) if WPS has not been set up on the wireless device.

PIN

This displays the PIN number of the WAP5705.

PIN Start

Click this button to perform wireless security information synchronization using the PIN 
configuration method.

PBC Start

Click this button to perform wireless security information synchronization using the Push 
Button Configuration (PBC) method.

Rescan

Click this button to search for available for WPS-enabled devices within transmission range 
and update this table.