ZyXEL Communications Corporation WAP7205 Manuel D’Utilisation

 Chapter 6 Wireless LAN

WAP7205 User’s Guide

The following table describes the labels in this screen.

Use this screen to allow wireless advanced features, such as the output power, and RTS/CTS Threshold.

Click Network > Wireless LAN 2.4G or 5G > Advanced. The screen appears as shown.

Figure 20   Network > Wireless LAN 2.4G or 5G > Advanced

The following table describes the labels in this screen. 

Table 18   Network > Wireless LAN 2.4G or 5G > MAC Filter

SSID Select

Select the SSID for which you want to configure MAC filtering.

MAC Address 
Filter

Select to turn on (Enable) or off (Disable) MAC address filtering.

Filter Action

Define the filter action for the list of MAC addresses in the MAC Filter Summary table.

Select Allow to permit access to the WAP7205, MAC addresses not listed will be denied access to 
the WAP7205. 

Select Deny to block access to the WAP7205, MAC addresses not listed will be allowed to access 
the WAP7205. 

MAC Filter Summary

Set

This is the index number of the MAC address.

MAC Address

Enter the MAC address of the wireless station that are allowed or denied access to the WAP7205.

Apply

Click Apply to save your changes back to the WAP7205.

Cancel

Click Cancel to reload the previous configuration for this screen.

Table 19   Network > Wireless LAN 2.4G or 5G > Advanced

RTS/CTS Threshold Data with its frame size larger than this value will perform the RTS (Request To Send)/CTS (Clear 

To Send) handshake. 

Note: If you select 802.11n, 802.11gn or 802.11bgn in the Wireless LAN 2.4G or 5G> 

General screen, this field is not configurable and the WAP7205 automatically 
changes to use the maximum value.