Garmin International Inc 02723 Manuel D’Utilisation

Temporarily place the transmitter in the preferred installation location, and

connect it to power and to the camera.
TIP: If you do not want to splice into the wiring of your vehicle for this test,

you can connect the transmitter and camera to a 12 Vdc battery.

Test the transmitter for correct operation by viewing the camera on the

compatible Garmin device.
NOTE: You may need to pair the camera to the Garmin device before you

can view the image and test the transmitter location (page 4).
If you do not see video on the Garmin device at the preferred installation

location, move the transmitter to another location and test it again.

Repeat steps 2–3 until the transmitter operates correctly.

Test the camera view by observing the video on the device.

If the camera does not provide the optimal view for your vehicle, move it to

another location and test it again.

Repeat steps 5–6 until the camera mounting location provides the optimal

view for your vehicle.
TIP: Make note of which direction is up when you are testing the camera view

to ensure correct permanent installation.

Before you permanently mount the camera, you should test the mounting location

for the optimal view for your vehicle (page 2).
If you have already connected the camera to the bracket, you must first

disassemble it.

Place the bracket 

À

 in the mounting location.

Select an option:
• If you are mounting the bracket directly on the surface of your vehicle,

mark the locations of the two holes on the bracket 

Á

.

• If you are installing the bracket on a license plate, remove one of the

license plate screws and clip the bracket in place so the hole on the

bracket 

Â

 lines up with the hole on the license plate.

Secure the bracket to the vehicle using either the included self-tapping

screws 

Ã

 or the license-plate screw you removed in step 2 

Ä

.

Place the camera in the bracket, and determine the best place for the camera

cable 

Å

 to enter the vehicle.

Using an appropriate drill bit, drill a hole for the camera cable to enter the

vehicle.

Feed the camera cable through the hole and route it to the transmitter

location.

Secure the camera in the bracket using the included hex bolts 

Æ

.

3