SMC Networks SMCKF01Z Manuel D’Utilisation

Holding the key fob in one 
hand, carefully insert the 

tip of a flat-head 
screwdriver into the casing 

seam. 

Push lightly and twist the 
screwdriver handle. 

Find the supplied CR2032 3-

volt lithium battery. 

Remove the circuit board 
and rubber button pad from 

the key fob casing. 

Place the rubber button pad 
on the circuit board so the shield 
icon is nearest the beveled end of 

the circuit board. 

Hold down the center 

 button 

and any other button while slowly 

inserting the battery in the battery 
slot (positive side away from the 
circuit board).  

When the LED flashes green, 
release the buttons immediately. 
The LED flashes green three times every five seconds. 

The device is defaulted and in Search mode. The key fob 
is now ready to be added to the TouchScreen. 

Replace the circuit board in the key fob casing. 

 

From the Home screen, touch the Settings widget. 

When the Keypad screen appears, touch the numbers 
enter your keypad code. 

to 

When the Settings menu appears, use the keypad to 

enter the Installer Code (this code is the same for all 
TouchScreens installed by your company). 
When the Technician keyboard pad appears, enter your 

Technician ID an

d touch Done. 

When the Technician Settings menu appears, select Key 
Fobs & Pads > Add a Key Fob. The Locating Key Fobs 
screen appears. 

Touch Next  

. The system scans the premises for key

that can be added. Key fobs must meet the followin

 fobs 

g 

requirements: 

Defaulted 

Not currently paired with another TouchScreen. 

Follow the system prompts to complete the add process 

and pair the key fob with the TouchScreen. 

When the system finds the key fob, press 
center 

and hold the 

 button to pair it with the TouchScreen. 

Press and hold the Arm Away or Arm Stay 
buttons to test the key fob’s connectivity 

to the TouchScreen. 

If no available key fobs are found or 

fewer are found than expected touch Cancel 

 Fob Add to return to the Technician 

Settings menu.  

Congratulations on purchasing your SMCWF01-Z Key Fob. 

The SMCMT02-Z Key Fob is a professional state-of-the-art device that allows you to arm and disarm your system from anywhere within or just outside your home. Disarming your security 
system with your key fob does not skip the Entry Delay period and does not require entering a key pad code. The SMCMT02-Z also provides an emergency alarm function anywhere within 
range of the TouchScreen. 

Deleting a key fob from the premises removes it from being 

used to perform actions in your security system. You should 
delete a key fob: 

¾

 

If the key fob is being relinquished by the customer. 

¾

 

To reset the key fob to factory default settings by 

deleting the key fob and re-adding it to the TouchScreen 
immediately. 

To delete a key fob from the TouchScreen:  

Perform steps A through D in step 2, “Adding a Key Fob 
to the TouchScreen”. 

When the Technician Settings menu appears, select Key 

Fobs & Pads > Delete a Key Fob. The Remove Key Fob 
screen appears. 

Touch the key fob icon that you want to delete.  

When a confirmation dialog appears, touch Yes to delete 
the key fob from the TouchScreen. 

 After deleting the key fob from the TouchScreen, press 
the 

 button on the key fob to reset the device to 

default and place it in Search mode so it can be added 
to a TouchScreen again.  

 

 

You have successfully your added key fobs.