Innovative Control Systems Inc IGWT-660098 Manuel D’Utilisation
LC 1200 Manual The LC unit 2-1
The LC unit
Specifications
Positioning
Mounting
Wiring
A Look Inside
Tamper Switch adjustment
Tuning
Positioning
Mounting
Wiring
A Look Inside
Tamper Switch adjustment
Tuning
Specifications
Power Requirements
Temperature
Weight
Location
Temperature
Weight
Location
Power Requirements
12V DC
0.5A for one 3101 Magnetic Lock
1.0A for two 3101 Magnetic Locks
1.0A for one 3000 Magnetic Lock
1.0A for one 3000 Magnetic Lock
Temperature
The LC unit and its associated peripherals
operate best in an ambient temperature between
35 and 90 degrees Fahrenheit. Operation outside
of this range may cause unexpected or
undesirable results, including premature
component or device failure.
operate best in an ambient temperature between
35 and 90 degrees Fahrenheit. Operation outside
of this range may cause unexpected or
undesirable results, including premature
component or device failure.
Weight
The LC unit weighs approximately 1 U.S.
pounds, which should be considered when
choosing mounting location and hardware.
pounds, which should be considered when
choosing mounting location and hardware.
Positioning
The recommended location of the LC unit is on
the latch side of the door with its lowest point
about 2 feet above the floor (Figure 2.1)
the latch side of the door with its lowest point
about 2 feet above the floor (Figure 2.1)
Mount the LC unit at least 3 inches away from
any type of metal including:
any type of metal including:
metal door frames
metal studs
metal lathe walls
metal electrical box
metal conduit
metal pipes
metal studs
metal lathe walls
metal electrical box
metal conduit
metal pipes
In addition, the LC unit should be positioned
within 18” maximum of the monitored door or
elevator to assure proper coverage. The
recommended distance is 3 to 6 inches.
within 18” maximum of the monitored door or
elevator to assure proper coverage. The
recommended distance is 3 to 6 inches.
Positioning the LC unit correctly will help in
avoiding unintended activation of a Tag in a
nearby room or a passerby. The goal is to
produce a Tx Activation Field that adequately
covers the doorway but does not extend into
nearby rooms.
avoiding unintended activation of a Tag in a
nearby room or a passerby. The goal is to
produce a Tx Activation Field that adequately
covers the doorway but does not extend into
nearby rooms.
Figures 2.1 through 2.4 show the recommended
location of the equipment in a typical door,
double door, elevator, and hallway application.
Use them for reference during installation.
location of the equipment in a typical door,
double door, elevator, and hallway application.
Use them for reference during installation.