Innovative Control Systems Inc IGWT-660098 Manuel D’Utilisation

To mount an LC unit, refer to Figure 2.5 and use 
the following instructions: 

1.  Remove the LC unit cover and screws. 

2.  Locate, align, mark-out, and drill 4 

mounting holes in the wall 
corresponding to the mounting holes of 
the LC unit. 

3.  Using appropriate hardware for the 

mounting surface, install the four 
anchors. 

4.  Install the upper screws leaving about a 

1/8

th

 of an inch exposed. 

5.  Make any wire accommodations (such 

as fishing wires through the back cover 
or planning conduit/panduit interface) 
that are easier completed with the LC 
unit unmounted. 

6.  When finished, install the last two 

mounting screws then tighten all 4 
mounting screws. 

7.  Note the Tamper Switch adjustment 

section on page 2-7. 

8.  Proceed to wiring. 

Wiring 

The LC unit uses a 12V DC plug-in for power. 
For instructions on wiring to the LC unit, refer 
to the chapter of the component you are 
interfacing with. 
Note: P3 pins 1 and 2 come from the factory 
with a jumper wire between them (see page 2-6).