Trimble Inc. TC900C Manuel D’Utilisation
4 Installing the SNR900 Network
2 4 SNR900 Operation Manual
4.4
Cabling Configurations
The SNR900 is typically configured as a rover, but the cables and
adapters necessary for other configurations are also available.
Table 4.2 summarizes the cabling items available or provided with the
SNR900 unit or available accessories.
adapters necessary for other configurations are also available.
Table 4.2 summarizes the cabling items available or provided with the
SNR900 unit or available accessories.
Table 4.2
SNR900 cabling and power accessories
4.4.1
Power and I/O Cable for Machine Installations
The cable shown in Figure 4.5 connects the SNR900 to either the
Trimble MS850 or the Trimble MS860™ GPS receiver on the
machine. The GPS receiver outputs power to the SNR900 through this
cable.
Trimble MS850 or the Trimble MS860™ GPS receiver on the
machine. The GPS receiver outputs power to the SNR900 through this
cable.
Item
Part number
Power and I/O cable for machine installations, 5 m (17
ft) 8-pin female Bendix connector on each end
ft) 8-pin female Bendix connector on each end
32942-17
Infrastructure/Base Station power and I/O cable, 7.5 m
(25 ft) 8-pin female Bendix, with Y-split to TA-3 power
connector, DBF-9, plus 12-pin Conxall
(25 ft) 8-pin female Bendix, with Y-split to TA-3 power
connector, DBF-9, plus 12-pin Conxall
38968-25
Machine service cable (21-pin female Bendix, with Y-
split to bare power leads and dual DBF-9 connector
split to bare power leads and dual DBF-9 connector
36938
DC power adapter cable with TA-3 connector and
battery clips
battery clips
44087-00
Reference Station/Configuration cable, 30 m (99 ft)
40942-99
SNR900.book Page 24 Friday, December 3, 2004 2:02 PM